1. Measure each window casing.
•Record each measurement on this convenient printable chart.
•Work left-to-right, floor-by-floor.
•The recorded height should be the measured height from top to bottom of the casing minus 1/4″. The recorded width should be the measured width from side to side of the casing minus 1/4″. This will give 1/8″ clearance all the way around.
|Design Wind Speed
Maximum Allowable PLYLOX™ Clip Spacing (inches)
Nominal Recessed Width of Window (Inches)
Clip Spacing in Inches on Vertical Edges
2. Cut 1/2″ plywood to the recorded size of each window.
•Mark each cut piece with its label, such as FF1, the window at the left front of the house on the first floor.
•If you keep the chart and label the plywood covers, you won’t need to label the casings.
3. Place the PLYLOX clips on each plywood cover (if the window is 24″x24″ or smaller, only two PLYLOX clips are needed).
•Each clip should be placed on the edge of the plywood cover no more than 24 inches apart.
•Make sure the tension legs are facing towards you.
4. Push the plywood covers with the PLYLOX tension legs to the outside firmly into the casing.
5. PLYLOX works as well in round windows as they do in rectangular windows. You can adjust the number of PLYLOX clips used to account for different shapes and sizes of windows.
1. Press in on the plywood sheet.
2. Put you finger behind the tension leg and pull the tension leg towards you. Work with the PLYLOX™ clips on one side of the plywood sheet. (A screwdriver can help)
3. As the tension legs are pulled away from the brick the plywood sheet comes right out. Carefully remove the plywood sheet from the window. For large sheets of plywood you may need a helper.
4. Remove PLYLOX™ clips from plywood and store in a dry place.
5. Store the plywood for re-use.